The ordinary machining center can also be used for high-speed machining of graphite after modification. Due to the sealing of the machining center itself
The performance is generally good. Closing the protective door can effectively prevent graphite dust from escaping. Therefore, the modification of the machining center
The construction is mainly dust collection transformation. For the transmission system located under the workbench, it is difficult to completely seal and prevent dust, but
Install a dust collecting pipe near it, pay attention to the dust prevention of the main shaft, and blow air to clean the tool handle when changing the tool to prevent
Dust adheres to the handle and is brought into the spindle. After each processing, the graphite dust shall be cleaned in time and the processing shall be cleaned
Center. The dust collection transformation is mainly to install dust collection devices. For the transformation of the processing center, the dust collection device should be installed
The dust collecting tube is simple in structure and easy to take materials. It can be refitted from ordinary plastic tubes, which is convenient to use,

Low cost, small dust collection area, the dust collection pipe can be installed in the position close to the processing area, and the dust collection pipe shall be installed as far as possible

The airflow direction is consistent with the discharge direction of graphite dust during processing, which can effectively collect dust